Home » Learning Library » Sweeping an Antenna: SWR Across a Band, Interactive

Learning Library · Amateur radio · 3

Sweeping an antenna

An SWR meter gives one number at one frequency, and only while you transmit. A swept measurement draws the whole band at once without keying the radio: where the antenna is resonant, how wide its 2:1 window is, and which way to trim.

A half-wave dipole swept across the band and a little either side. The shaded strip is the band. Simplified model: a series-resonant antenna with a Q of 12, typical of a wire dipole; real antennas vary with wire size, height, and surroundings.

Resonant frequency
SWR at resonance
2:1 bandwidth
SWR at band edges
To centre it in the band

Length sets the frequency

Dipole length (ft) ≈ 468 ÷ frequency (MHz)

A half-wave dipole is resonant where its reactance crosses zero, and the classic starting point for a wire dipole is 468 ÷ f in feet. The real resonance depends on wire size, height, insulation, and what is nearby, so you cut a little long and trim. Resonant frequency scales inversely with length: 1 % shorter is 1 % higher in frequency.

At resonance the SWR is set by the feed-point resistance. A dipole in free space is about 73 Ω; at practical heights it is often between about 50 and 75 Ω, which is why a well-cut dipole on 50 Ω coax may bottom out at 1.2 or 1.4 rather than 1.0. Away from resonance, reactance grows and the SWR climbs. How quickly it climbs is the antenna's Q, and it decides the 2:1 bandwidth.

Try this

  • On 40 m, set the length to 65.5 ft. Resonance is 7.145 MHz, the middle of the band, and the trim readout says the length is right.
  • Lengthen the wire to 67.0 ft. The dip slides down to 6.985 MHz, below the band, and the readout says to shorten it.
  • Pick 80 m. Its 2:1 bandwidth is much narrower than the 500 kHz band, so one dipole cannot cover all of 80 m below 2:1.
  • Set the feed-point resistance to 50 Ω and switch to return loss. The dip deepens to the bottom of the screen: a perfect match at one frequency.

Two ways to sweep it. A vector network analyzer measures S11 directly, with magnitude and phase, so it can show SWR, return loss, or the feed-point impedance; the UTS3000A series has one built in. A spectrum analyzer with a tracking generator, such as the UTS3000T+ series, sweeps return loss through an external return-loss bridge or directional coupler. Calibrate at the end of the feed line, or include the coax in the measurement and remember it flatters the SWR (previous explainer).

See the whole band before you climb the tower. Analyzers with a built-in VNA or tracking generator.

Shop UNI-T spectrum analyzers

UNI-T Learning Library. Design. Debug. Deploy.™